Filter
Top Products
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Setting Up Device Management
4-20
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Step 5 To enable and configure Telnet:
a. Select SERVICES > Telnet/SSH.
b. Enable Telnet.
c. (Optional) Enable Teletype.
d. Enter the number of Columns.
e. Enter the number of Lines
f. Click Apply.
Step 6 Select SNMP from the menu.
a. After Simple Network Management Protocol (SNMP), select Enabled.
b. Click Apply.
Step 7 In the SNMP Request Communities section, enter a community string for the ISO
view:
Note This community string is required for the access point to be discovered
and managed by the WLSE. Devices that do not have an ISO view will be
placed in the Misconfigured Devices group after discovery, and faults will
be generated. The fault messages refer to a “dot 11 MIB” problem.
a. Enter the community string in the SNMP Community field.
b. Enter iso in the Object Identifier (optional) field.
c. Click Read-Only.
d. Click Apply.
Step 8 In the SNMP Request Communities section, enter a read/write community string.
Note This community string is required to enable firmware updates and
configuration downloads on the access point.
a. Enter the community string in the SNMP Community field.
b. Click Read-Write.
c. Click Apply.