Filter
Top Products
4-19
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Setting Up Device Management
The following optional commands are recommended:
width 80
length 24
Step 9 Exit global configuration mode, then enter the following command:
write memory
Set Up IOS Access Points by Using the Web Interface
Step 1 Log into the Web interface of the AP 1100 or AP 1210.
Step 2 Select SERVICES from the menu, then click CDP:
a. After Cisco Discovery Protocol (CDP), select Enabled.
b. Click Apply.
Note If you do not want to use CDP for discovery, see Discovering Devices,
page 4-30, for alternative methods.
Step 3 To push configuration templates to IOS access points, you can use either Telnet
or SSH (secure shell protocol). You must configure either Telnet or SSH; you can
configure both. See Steps 4 and 5 for procedures.
Step 4 To enable and configure SSH (secure shell protocol), enter the following:
a. Select SERVICES > Telnet/SSH.
b. Enable Secure Shell.
c. Enter a System Name.
d. Enter a Domain Name (for example, cisco.com).
e. (Optional) Enter the RSA key size
f. (Optional) Enter the Authentication Timeout.
g. (Optional) Enter Authentication Retries.
h. Click Apply.