Filter
Top Products
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Setting Up Device Management
4-14
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Setting Up Devices
You must set up network devices so the WLSE can discover and manage them.
This section describes both required and optional setup tasks for:
• Non-IOS access points—see Set Up Non-IOS Access Points and Wireless
Bridges, page 4-14
• IOS access points—see Set Up IOS Access Points, page 4-16
• Routers and switches—see Set Up Routers and Switches, page 4-21
• AAA servers—see Set Up AAA Servers, page 4-22
Set Up Non-IOS Access Points and Wireless Bridges
You can set up access points and bridges in two ways:
• By using the WLSE’s automatic configuration option for first-time device
configuration (select Configuration > Auto Update > Startup
Configuration). For more information, see the online help or the User Guide
for the Wireless LAN Solution Engine, Release 2.5.
• By opening a web browser session on each device and performing the tasks
in the following table. To use this method, you must first configure each
access point or bridge for web browsing.
Table 4-6 Setup Procedures for Non-IOS Access Points and Bridges
Tasks Procedure Notes
1. Enable Cisco
Discovery Protocol
(CDP).
1. In the Summary Status page, click Setup.
2. Under Services: Cisco Services, click
Cisco Discovery Protocol.
3. Select Enabled. Click Apply or OK.
CDP is used by the WLSE to
discover devices on the
network.
1