Filter
Top Products
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Setting Up Device Management
4-16
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Set Up IOS Access Points
You can set up IOS-based access points (Cisco Aironet 1100 and 1210 access
points) in three ways:
• Use the WLSE’s automatic configuration option for first-time device
configuration (select Configuration > Auto Update > Startup
Configuration). For more information, see the online help or the User Guide
for the CiscoWorks Wireless LAN Solution Engine, 2.5.
• Log in to each device by using Telnet or SSH and using the device’s CLI
commands. See Set Up IOS Access Points by Using the Device CLI,
page 4-17.
5. Add an HTTP user
with the ability to
modify firmware, and
enable the User
Manager.
You can use the same
user that you created
in Task 4, if the user
has firmware
privileges.
1. In the Summary Status page, click Setup.
2. Click Security.
3. Click User Information; then click Add
New User.
4. Enter a username and password and select
Firmware; then click Apply.
5. Navigate back to the Security Setup page
and click User Manager.
6. Select Enabled; then click Apply or OK.
This allows configuration
uploads from the WLSE to
access points.
You must also enter HTTP
users and passwords on the
WLSE (see Enter HTTP
Credentials for Non-IOS
Access Points, page 4-24).
6. Set up TFTP as the
transfer protocol
between the WLSE
and access points.
1. In the Summary Status page, click Setup.
2. Under Services, click FTP.
3. Use the pulldown menu to select TFTP as
the file transfer protocol.
4. In the Default File Server text box, enter
the IP address of the WLSE.
5. Click Apply or OK.
TFTP is used for transferring
configuration changes to
access points.
1. If you do not want to enable CDP, see the Discovering and Managing Devices, page 4-29 for alternative methods of
discovering devices.
Table 4-6 Setup Procedures for Non-IOS Access Points and Bridges (continued)
Tasks Procedure Notes