Filter
Top Products
4-15
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Setting Up Device Management
2. Enable SNMP.
(Optional) Set the
location.
(Optional) Set the
system name and
system contact.
1. In the Summary Status page, click Setup.
2. Under Services, click SNMP.
3. Select Enabled.
4. Enter a System Name, System Location,
and System Contact.
5. Click Apply or OK.
SNMP is required for the
WLSE to discover devices,
populate reports, transfer
configuration information to
devices, and upgrade device
firmware.
Setting the system name and
system location provides this
information when you display
device details.
3. Set the read
community string.
1. In the Summary Status page, click Setup.
2. Under Services, click Security.
3. Click User Information; then click Add
New User.
4. Create a user with all privileges,
including SNMP, Firmware, Write, and
Admin privileges.
5. In addition, for access points that are
running a firmware version earlier than
12.01(T), assign Ident privileges.
6. Click Apply or OK.
The read community string is
required for device discovery
and populating reports.
4. Set the read-write
community string.
1. In the Summary Status page, click Setup.
2. Under Services, click Security.
3. Click User Information; then click Add
New User.
4. To create an user with SNMP read/write
privileges, enter a username and
password and select the Write, SNMP,
Firmware, and Admin privileges.
5. Click Apply or OK.
The read-write community
string is required for
configuration and firmware
jobs.
Table 4-6 Setup Procedures for Non-IOS Access Points and Bridges (continued)
Tasks Procedure Notes