Filter
Top Products
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Setting Up Device Management
4-24
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Adding Device Credentials to the WLSE
This section provides procedures for entering the following required device
credentials on the WLSE:
• For all managed devices, you must enter SNMP credentials.
• For access points, the following additional credentials are required:
–
For IOS-based access points, you must enter Telnet or SSH credentials
and IOS HTTP port settings.
–
For non-IOS access points, you must enter HTTP credentials.
• If you are using Wireless Domain Services (WDS), you must enter RADIUS
credentials.
Enter HTTP Credentials for Non-IOS Access Points
HTTP credentials are required for downloading configuration files to non-IOS
access points and for uploading configuration from such access points. The same
password must be set on each access point, as described in Table 4-6 on
page 4-14. You can enter as many usernames and passwords as necessary.
To enter HTTP usernames and passwords:
Step 1 Select Devices > Discover > Device Credentials > HTTP User/Password.
Step 2 To add a username and password:
a. Enter the access point IP address or range of IP addresses that will use this
username and password.
b. Enter the username.
c. Enter the password.
d. Click Save. The IP address and username are added to the Current Entries
textbox.
Step 3 Repeat step 2 to add credentials for more devices.