Filter
Top Products
4-27
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Setting Up Device Management
Step 2 To add a port:
a. Enter the IP address or range of IP addresses that use this port number.
b. Enter the port number.
c. Click Save.
Step 3 Repeat Step 2 to add more IP addresses and ports.
Enter WLCCP Credentials for Wireless Domain Services (WDS)
If you are using WDS on your wireless LAN, you must set up an AAA server (if
you don’t already have an AAA server set up), add WLCCP credentials, and
configure the access point that is providing WDS.
Configure an AAA Server
To set up the AAA server, see Set Up AAA Servers, page 4-22.
Configure the WLSE for WDS
To configure the WLSE to authenticate with the access point providing WDS:
Step 1 Select Devices > Discover > Device Credentials > WLCCP Credentials.
Step 2 Enter the Radius User Name and Radius Password.
This is the user name and password that you set for the WLSE on the AAA server.
Step 3 Click Save.
Configure the WDS Access Point
WDS is currently supported by on the Cisco Aironet 1100 and 1200 IOS-based
access points.
To configure the access point that will provide Wireless Domain Services:
Step 1 Log in to the CLI interface.