Filter
Top Products
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Setting Up Device Management
4-28
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Step 2 In configure mode, enter the following command:
# wlccp wnm ip address x.x.x.x
where x.x.x.x is the WLSE’s IP address.
Step 3 To verify that authentication is configured properly, enter the following command
# show wlccp wnm status
The command returns a status of SECURITY KEYS SETUP if the authentication
is successful.
Adding AAA Servers to the WLSE
Use the following procedure to add information about all AAA servers to be
monitored by the WLSE. For information about configuring an AAA server for
monitoring, see Set Up AAA Servers, page 4-22.
Step 1 Select Devices > Discover > AAA Server.
Step 2 Select the server type: EAP-MD5, LEAP, PEAP, or RADIUS.
Step 3 Select Add Server. and complete the following:
Step 4 Click Add.
Step 5 Repeat Steps 2-4 for each AAA server you want to add.
Text Box Description
Server Name Hostname or IP address of the AAA server.
Server Port Port on the server that is used for authentication; use port 1645.
Username Client username that you entered on the AAA server.
Password Client password that you entered on the AAA server.
Secret Shared secret key that you entered on the AAA server.