Filter
Top Products
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Setting Up Device Management
4-22
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Set Up AAA Servers
The WLSE can monitor the performance of AAA (Authentication, Authorization,
and Accounting) services provided by:
• CiscoSecure ACS Server.
• Cisco Access Registrar (CAR) (RADIUS services only).
The WLSE supports LEAP, RADIUS, EAP-MD5, and PEAP servers. For
information on supported versions of CiscoSecure ACS, see the Supported
Devices Table for WLSE 2.5 on Cisco.com.
An AAA server is required for using Wireless Domain Service (WDS). For more
information about configuring for WDS, see Enter WLCCP Credentials for
Wireless Domain Services (WDS), page 4-27.
Note For PEAP, in addition to the procedures in this section, you must also do the
following on the ACS server: set up a certificate and private key and enable PEAP.
For more information, see the Cisco Secure ACS documentation.
Step 1 Log into the CiscoSecure ACS Server that will provide authentication services to
the wireless network.
3. (Optional) Set
the system name,
contact, and
location
variables.
On IOS-based devices, enter configuration mode and
use the following commands:
• Set system name—hostname name.
• Set system contact—snmp contact contact.
• Set location—snmp location location.
On Hybrid OS-based Catalyst switches, enter enable
mode and use the following commands:
• Set system name—set system name name.
• Set system contact—set system contact contact.
• Set location—set system location location.
These variables make the
device more manageable.
The system name, system
contact, and location will
appear in the device detail
displays.
Table 4-7 Set Up Procedures for Routers and Switches (continued)
Task Procedure Notes