Filter
Top Products
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Setting Up Device Management
4-18
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Step 5 To set up SNMP community strings, enter the following commands in the
sequence shown.
• The first two commands create an ISO view and set the read-only community
string for discovery, faults, and reports. IOS access points that do not have an
ISO view will be placed in the Misconfigured Devices group after discovery
and faults will be generated. The fault messages refer to a “dot11 MIB”
problem.
• The third command sets a read/write community string for updating access
point firmware and configuring access points.
snmp-server view iso iso included
snmp-server community
community_string view iso RO
snmp-server community community_string RW
Note These community strings must also be entered on the WLSE before the
device can be discovered and managed. See Enter SNMP Community
Strings for All Managed Devices, page 4-25.
Step 6 To push configuration templates to IOS access points, you can use either Telnet
or SSH. You must configure either Telnet or SSH or both. See Steps 7 and 8 for
procedures.
Step 7 To enable and configure SSH, enter the following commands. After the prompt
for the number of bits in the modules, press Return to accept the default or enter
a value.
hostname hostname
ip domain-name domain_name
crypto key generate rsa
How many bits in the modulus [512]:
In the preceding commands, hostname is the hostname of the access point, and
domain_name is your domain name (for example, cisco.com).
The following commands are optional, but are recommended:
ip ssh time-out 120
ip ssh authentication-retries 3
Step 8 To configure Telnet, enter the following commands. Telnet is enabled by default.
line 0 4
no access-class 111 in