Filter
Top Products
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Next Steps—Finish Initial Configuration
4-12
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Next Steps—Finish Initial Configuration
For the remainder of the configuration, you use the WLSE’s Web interface.
Table 4-5 Quick Reference for WLSE Configuration and Device Setup
Task Steps References
Log in and verify
connectivity.
Verify that you can connect to the WLSE via
HTTP and HTTPS.
Logging into the Web Interface
and Verifying Connectivity,
page 4-13
Configure devices
to be managed or
monitored by the
WLSE.
• Configure IOS access points. Set Up IOS Access Points,
page 4-16
• Configure non-IOS access points. Set Up Non-IOS Access Points
and Wireless Bridges, page 4-14
• Configure routers and switches. Set Up Routers and Switches,
page 4-21
• Configure AAA servers. Set Up AAA Servers, page 4-22
Enter device
credentials on the
WLSE.
Enter SNMP credentials for all devices and
other credentials, depending on device type
and WLSE features you will be using.
Adding Device Credentials to
the WLSE, page 4-24
Enter information
about AAA servers.
Enter information about all AAA servers to be
monitored.
Adding AAA Servers to the
WLSE, page 4-28
Discover and
manage devices.
• Discover devices by using the discovery
wizard or importing devices.
• Make sure all devices to be managed are
in the managed state.
Discovering and Managing
Devices, page 4-29
(Optional) Add
additional users.
You can add additional users and specify their
privileges by assigning roles to them.
Adding Users, page 4-36