Filter
Top Products
Install the Management Server on the First Host
49
server 0.xenserver.pool.ntp.org
server 1.xenserver.pool.ntp.org
server 2.xenserver.pool.ntp.org
server 3.xenserver.pool.ntp.org
c. Restart the NTP client.
# service ntpd restart
d. Make sure NTP will start again upon reboot.
# chkconfig ntpd on
7. Repeat all of these steps on every host where the Management Server will be installed.
8. Continue to Section 5.4.3, “Install the Management Server on the First Host”.
5.4.3. Install the Management Server on the First Host
The first step in installation, whether you are installing the Management Server on one host or many,
is to install the software on a single node.
Note
If you are planning to install the Management Server on multiple nodes for high availability, do not
proceed to the additional nodes yet. That step will come later.
1. Download the CloudStack Management Server onto the host where it will run. Get the software
from the following link.
https://www.citrix.com/English/ss/downloads/.
You will need a MyCitrix account
1
.
2. Install the CloudStack packages. You should have a file in the form of “CloudStack-VERSION-N-
OSVERSION.tar.gz”. Untar the file and then run the install.sh script inside it. Replace the file and
directory names below with those you are using:
# tar xzf CloudStack-VERSION-N-OSVERSION.tar.gz
# cd CloudStack-VERSION-N-OSVERSION
# ./install.sh
You should see a few messages as the installer prepares, followed by a list of choices.
3. Choose M to install the Management Server software.
> M
1
http://www.citrix.com/lang/English/publicindex.asp?destURL=%2FEnglish%2FmyCitrix%2Findex.asp%3F