Filter
Top Products
w
DAC is supported only on 10G ports. Do not insert a DAC into a 1G port.
w
Do not attempt to unplug the integrated copper cable from the transceiver and
insert a fiber cable into the transceiver.
Installing a Direct Attach Cable
Note: The illustrations in the following figures are only for reference and might not
represent the actual NetScaler appliance.
To install or remove a direct attach cable
1. To install the DAC, slide it into the 10G port on the appliance, as shown in the
following figure. You will hear a click when the DAC properly fits into the port.
Figure 1-21. Inserting a DAC into the 10G port
2. To remove the DAC, pull the tab on the top of the DAC, and then pull the DAC out
of the port, as shown in the following figure.
Figure 1-22. Removing a DAC from the 10G port
Citrix NetScaler Hardware Installation and Setup Guide
37