Filter
Top Products
Caution: NetScaler appliances do not support 1G SFP transceivers from vendors
other than Citrix Systems. Attempting to install third-party 1G SFP transceivers on your
NetScaler appliance voids the warranty.
Insert 1G SFP transceivers into the 1G SFP ports on the front panel of the appliance.
Frequent installation and removal of transceivers shortens their life span. Follow the
removal procedure carefully to avoid damaging the 1G SFP transceiver or the
appliance.
Caution: Do not install the transceivers with the cables attached. Doing so can
damage the cable, the connector, or the optical interface of the transceiver.
To install a 1G SFP transceiver
1. Remove the 1G SFP transceiver carefully from its box.
Danger: Do not look directly into fiber optic transceivers or cables. They emit
laser beams that can damage your eyes.
2. Align the 1G SFP transceiver to the front of the 1G SFP transceiver port on the
front panel of the appliance, as shown in the following figure.
Note: The illustration in the following figures might not represent your actual
appliance.
Figure 3-6. Installing a 1G SFP transceiver
3. Hold the 1G SFP transceiver between your thumb and index finger and insert it into
the 1G SFP transceiver port, pressing it in until you hear the transceiver snap into
place.
Citrix NetScaler Hardware Installation and Setup Guide
81