Filter
Top Products
Access Gateway.
If you are configuring your appliance as an Access Gateway, see "Access Gateway
9.3, Enterprise Edition."
Note: For information about deploying a high availability (HA) pair, see
"Configuring High Availability."
Using the Setup Wizard
To configure the appliance by using the Setup Wizard in the configuration utility, you
need an administrative computer configured on the same network as the appliance. To
run the configuration utility, the Java RunTime Environment (JRE) version 1.4.2_04 or
later must be installed on the workstation or laptop. You can use the Setup Wizard to
configure the following initial settings on the appliance:
w
System IP address and subnet mask
w
Subnet or Mapped IP address and subnet mask
w
Host name
w
Default gateway
w
Time zone
w
Licenses
w
Administrator password
Important: Before running the Setup Wizard, you should download your licenses from
the Citrix Web site and put them in a location on your computer or another device
where you can access them from your Web browser during configuration.
Note: If the appliance is configured with the default IP address, licenses are not
installed on the appliance, or the mapped or subnet IP address is not configured, the
configuration utility automatically opens the Setup Wizard when you log on to the
appliance.
To configure initial settings by using the Setup
Wizard
1. In a Web browser, type: http://192.168.100.1
Note: The NetScaler software is preconfigured with a default IP address and
associated netmask. The default IP address is 192.168.100.1 and the default
netmask is 255.255.0.0.
Citrix NetScaler Hardware Installation and Setup Guide
93