Filter
Top Products
Important: The 10-gigabit ports on this appliance are labeled 10/1 and 10/2.
The following figure shows the back panel of the MPX 9700/10500/12500/15500
appliances, including the 10G model and FIPS model.
Figure 1-41. Citrix NetScaler MPX 9700/10500/12500/15500, MPX
9700/10500/12500/15500 FIPS, and MPX 9700/10500/12500/15500 10G, back
panel
*The USB Port is reserved for a future release.
The following components are visible on the back panel of the MPX
9700/10500/12500/15500, including the 10G model and FIPS model:
w
Four GB removable CompactFlash Card that is used to store the NetScaler software.
w
Power Switch, which turns off power to the appliance, just as if you were to unplug
the power supply. Press the switch for five seconds to turn off the power.
w
Removable Hard Disk Drive that is used to store user data.
w
USB Port (reserved for a future release).
w
Non-maskable interrupt (NMI) Button that is used at the request of Technical
Support and produces a core dump on the NetScaler. You must use a pen, pencil, or
other pointed object to press this red button, which is recessed to prevent
unintentional activation.
w
Disable Alarm Button. This button is functional only when the appliance has two
power supplies.
Press this button to stop the power alarm from sounding when you have plugged the
appliance into only one power outlet or when one power supply is malfunctioning
and you want to continue operating the appliance until it is repaired.
w
Dual Power Supplies, each rated at 450 watts, 110-220 volts.
Citrix NetScaler Hardware Installation and Setup Guide
49