Filter
Top Products
w
Two 10/100/1000Base-T copper Ethernet management ports (RJ45), numbered 0/1
and 0/2 from left to right. The management port is used to connect directly to the
appliance for system administration functions.
w
Six 10/100/1000Base-T copper Ethernet ports numbered 1/1, 1/2, 1/3, 1/4, 1/5,
and 1/6 from left to right.
The following figure shows the back panel of the MPX 5550/5650 appliance.
Figure 1-31. Citrix NetScaler MPX 5550/5650 appliance, back panel
The following components are visible on the back panel of the MPX 5550/5650
appliance:
w
160 GB removable solid-state drive, which is used to store the NetScaler software
and the user data.
w
Power switch, which turns off power to the appliance, just as if you were to unplug
the power supply. Press the switch for five seconds to turn off the power.
w
USB port (reserved for a future release).
w
Non-maskable interrupt (NMI) button, which is used at the request of Technical
Support to produce a NetScaler core dump. You must use a pen, pencil, or other
pointed object to press this red button, which is recessed to prevent unintentional
activation.
w
Single power supply, rated at 300 watts, 110-220 volts.
Citrix NetScaler MPX 7500 and MPX 9500
The Citrix NetScaler MPX 7500/9500 are 1U appliances, each with 1 quad-core
processor, and 8 gigabytes (GB) of memory. The MPX 7500/9500 appliances are
available in two port configurations: 8x10/100/1000Base-T copper Ethernet ports and
4x1G SFP + 4x10/100/1000Base-T copper Ethernet ports.
The following figure shows the front panel of the MPX 7500/9500 (8x10/100/1000Base-
T copper Ethernet ports) appliances.
Citrix NetScaler Hardware Installation and Setup Guide
43