Filter
Top Products
Figure 1-39. Citrix NetScaler MPX 9700/10500/12500/15500 10G, front panel
The following figure shows the front panel of the MPX 9700/10500/12500/15500 FIPS.
Figure 1-40. Citrix NetScaler MPX 9700/10500/12500/15500 FIPS, front panel
*The FIPS Management Port (Level 3 Mode) is reserved for a future release.
Caution: Do not insert a USB device into the FIPS Management Port. This will
cause the FIPS card to fail.
Depending on the model, the appliance has the following ports:
w
FIPS Management Port (reserved for a future release).
w
RS232 serial Console Port.
w
Two 10/100/1000Base-T copper Ethernet Management Ports (RJ45), numbered 0/1
and 0/2 from left to right. These ports are used to connect directly to the appliance
for system administration functions.
w
Network Ports
• MPX 9700/10500/12500/15500. Eight copper or fiber 1G SFP ports numbered 1/1,
1/2, 1/3, and 1/4 on the first row from left to right, and 1/5, 1/6, 1/7, and 1/8
on the second row from left to right. Eight 10/100/1000BASE-T copper Ethernet
Ports (RJ45) numbered 1/9, 1/10, 1/11, and 1/12 on the third row from left to
right, and 1/13, 1/14, 1/15, and 1/16 on the fourth row from left to right.
• MPX 9700/10500/12500/15500 10G and MPX 9700/10500/12500/15000 FIPS. Two
10G SFP+ Ports numbered 10/1 and 10/2 on the top row, eight 1-gigabit copper
or fiber 1G SFP Ports numbered 1/1, 1/2, 1/3, and 1/4 on the middle row from
left to right, and 1/5, 1/6, 1/7, and 1/8 on the bottom row from left to right.
Chapter 1 Introduction to the Hardware Platforms
48