Compaq AP200 Personal Computer User Manual


 
2-8
Software
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
File Name: C-CH02.DOC Last Saved On: 12/15/98 4:21 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Computer Setup
Continued
Task Computer Setup Selection
Set resources for onboard system devices
(serial port, parallel port, and so forth)
Select
Advanced,
then select
Onboard
Devices.
View the currently installed PCI devices and
their IRQ settings and/or and reconfigure IRQ
settings for these devices or disable them
entirely
NOTE
: This option will not appear if there
are non PnP devices currently installed.
Select
Advanced,
then select
PCI
Devices.
View the current settings of Plug and Play
(PnP) devices and set resources for installed
boards
Select
Advanced,
then select
ISA PnP
Devices.
Enable/disable PCI bus mastering, PCI reset
on warm boot, and PCI VGA palette snooping
Select
Advanced,
then select
Bus
Options
.
Set ISA back-to-back I/O (fast/legacy) delay
and bus priority (ISA/PCI)
Select
Advanced,
then select
Bus
Options
.
Set the printer mode (flexible/standard) Select
Advanced,
then select
Device
Options.
Set the
Num Lock
state at power-on Select
Advanced,
then select
Device
Options.
Specify which VGA controller is the primary
(or boot) VGA controller
NOTE:
This selection appears only if there
are multiple PCI graphics controllers in your
system.
Select
Advanced,
then select
PCI VGA
Configuration.
Save the system configuration to a blank
1.44 MB diskette
Select
File,
then select
Save to Floppy.
Restore the system configuration from a
diskette
Select
File,
then select
Restore from
Floppy.
Restore factory default settings and exit
Computer Setup
Select
File,
then select
Set Defaults and
Exit.
Exit Computer Setup without applying or
saving any changes
Select
File,
then select
Ignore Changes
and Exit.
Save changes to the system configuration
and exit Computer Setup
Select
File,
then select
Save Changes
and Exit.