Filter
Top Products
4-20
Hardware Upgrades
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
File Name: E-CH04.DOC Last Saved On: 1/19/99 9:40 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
4. Slide the expansion board into the expansion slot and press it firmly into
place.
Figure 4-13. Installing an expansion board
The processor in your workstation may look slightly different than the one
pictured.
NOTE: When you install an expansion board, make sure you press firmly on
the board so that the whole connector seats properly in the expansion board
slot
5. Replace the screw at the side of the expansion slot.
6. Replace the workstation access panel.
7. Connect external cables to the installed board, if needed.
8. Plug the network cable back into the system. Plug the power cord back
into the grounded AC outlet. Reconnect external devices.
9. Reconfigure the workstation, if necessary. See the “When to
Reconfigure the Workstation” section in this chapter.