Filter
Top Products
Understanding the System Menus |
103
❚
Admin Settings >
System Settings
Use System Settings to configure the power saving mode, warning tones, time-out
duration, display language, and job log auto print settings.
❚
Admin Settings > System Settings >
General
Configures general settings for the printer.
❚
Admin Settings > System Settings > General >
Power Saver Timer
Specifies the time for transition to power saver mode.
NOTE:
• Your printer enters Deep Sleep mode 11 minutes after it finishes a job (the factory default).
When you specify 1 minute for Sleep, the printer enters power saver mode 1 minute
after it finishes a job. This uses much less energy, but requires more warm-up time for
the printer. Specify 1 minute if the printer shares an electrical circuit with room lighting
and you notice lights flickering.
Select a high value if the printer is in constant use. In most circumstances, this keeps the
printer ready to operate with minimum warm-up time.
Select a medium value if you want a balance between energy consumption and a shorter
warm-up period.
The printer returns to the standby mode from the power saver mode when it receives
data from the computer or remote fax machine. You can also change the status of the
printer to the standby mode by pressing any button on the operator panel.
❚
Admin Settings > System Settings > General >
Date & Time
Specifies the date and time formats.
Print On Error Prints the protocol monitor report only when an error occurs.
Print Disable Does not print the protocol monitor report.
Sleep Specifies the time taken by the printer to enter the Sleep mode after it
finishes a job.
Deep Sleep Specifies the time taken by the printer to enter the Deep Sleep mode
after it has entered Sleep mode.
Power Off Timer Specifies whether to enable the Power Off Timer and the time taken
by the printer to enter the Power Off Timer mode after it has entered
the Deep Sleep mode.
Time Zone Sets the time zone.
Date Sets the date depending on the Format settings.
Format Sets the date format.
Time Sets the time.
Format Sets the time format.