Filter
Top Products
178
| Dell™ Printer Configuration Web Tool
NOTE:
• If IPsec is enabled with incorrect settings, you must disable it using the IPsec menu on the
operator panel.
802.1x
Specifies the settings for IEEE 802.1x authentication for encrypted communication to the
printer.
NOTE:
• This is available on Dell H625cdw and Dell H825cdw.
IP Filter
Specifies whether to enable the IP filter feature, which only allows communication with
devices whose IP addresses are registered in the printer.
NOTE:
• This feature does not apply to communication via Wi-Fi Direct.
IPsec Settings Protocol Select the check box to enable the protocol.
IKE Pre-Shared Key is displayed for IKE.
Pre-Shared Key Sets a shared key. Up to 255 alphanumeric characters,
periods, and hyphens can be used.
Re-enter Pre-Shared
Key
Enter the shared key again to check it.
IKE SA Lifetime Sets the lifetime for IKE SA from 5 to 28,800 minutes.
IPsec SA Lifetime Sets the lifetime for IPsec SA from 5 to 2,880 minutes.
DH Group Sets the DH group.
PFS Select the check box to enable the PFS setting.
Remote peers IPv4
address
Sets the IP address to connect to.
Remote peers IPv6
address
Sets the IP address to connect to.
Non IPsec
communication
policy
Allows communication with a device which does not
support IPsec.
Configure 802.1x Enable IEEE
802.1x
Select the check box to enable IEEE 802.1x
authentication.
Authentication
Method
EAP-MD5 Selects the authentication method to use for
IEEE 802.1x authentication.
EAP-MS-
CHAPv2
PEAP/MS-
CHAPv2
Login Name:
(Device Name)
Sets the login name (device name) for IEEE
802.1x authentication using up to 128
alphanumeric characters.
Password Sets the login password for IEEE 802.1x
authentication using up to 128 alphanumeric
characters.
Re-enter
Password
Confirms the set login password.