Filter
Top Products
94
| Understanding the System Menus
❚
Admin Settings > Network >
Ethernet
NOTE:
• When using a wired network, the Wi-Fi | WPS menu is not available.
Checks or specifies wired network settings.
❚
Admin Settings > Network > Ethernet >
IP Mode
Configures the IP mode.
❚
Admin Settings > Network > Ethernet >
TCP/IP
Configures TCP/IP settings.
Paired Device Displays the status of the Wi-Fi Direct
connections between the printer and up to 3
Wi-Fi mobile devices.
Disconnect All Disconnect now Disconnects all the Wi-Fi Direct connections
right now.
Disconnect and
Reset Passphrase
Disconnects the Wi-Fi Direct connections and
resets the passphrase.
SSID Displays the name that identifies the Wi-Fi
Direct network. You can also specify the name
with up to 32 alphanumeric characters.
"DIRECT-XX" cannot be changed. Check it when
selecting the Wi-Fi Direct network name on
your mobile device.
Passphrase Displays the passphrase. Check it when entering
the passphrase into your mobile device.
Print Passphrase Prints the passphrase. Check it when entering
the passphrase into your mobile device.
Reset Passphrase Resets the passphrase.
WPS Setup Configures the Wi-Fi Direct network using WPS.
Push Button
Configuration
Configures the Wi-Fi Direct network with Wi-Fi
Protected Setup-Push Button Configuration
(WPS-PBC).
PIN Code Configures the Wi-Fi Direct network using PIN
code assigned by the printer.
Print PIN Code Prints the PIN code. Check it when entering PIN
assigned to the printer into your mobile device.
Reset Code Resets the PIN code.
Dual Stack Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv6 Mode Uses IPv6 to set the IP address.