Filter
Top Products
92
| Understanding the System Menus
❚
Admin Settings > Network > Wi-Fi > Wi-Fi Setup Wizard > Manual SSID Setup > SSID >
Ad-hoc
Selects to configure the wireless setting without the access point such as a wireless
router.
❚
Admin Settings > Network > Wi-Fi >
WPS Setup
NOTE:
• WPS Setup is available only when the printer is connected using the wireless network.
• WPS Setup is available on Dell H625cdw and Dell H825cdw.
Configures the wireless network using WPS.
❚
Admin Settings > Network > Wi-Fi >
IP Mode
Configures the IP mode.
❚
Admin Settings > Network > Wi-Fi >
TCP/IP
Configures TCP/IP settings.
No Security Configures the wireless setting without specifying the
encryption type from WEP.
WEP Specifies the WEP key to use through the wireless
network. For 64bit keys, up to 10 hexadecimal characters
can be entered. For 128bit keys, up to 26 hexadecimal
characters can be entered.
Transmit Key Specifies the transmit key from WEP Key 1 - 4.
Push Button Configuration Configures the wireless setting with Wi-Fi Protected Setup-Push
Button Configuration (WPS-PBC) .
PIN Code Configures the wireless setting using the PIN code assigned by the
printer. You can also print the PIN code. Check it when entering PIN
assigned to the printer into your computer.
Dual Stack Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv6 Mode Uses IPv6 to set the IP address.
Get IP Address AutoIP Sets the IP address automatically. A random value in the
range of 169.254.1.0 to 169.254.254.255 that is not
currently in use on the network is set as the IP address.
The subnet mask is set as 255.255.0.0.
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP address
manually on the operator panel.
IP Address When an IP address is being set manually, the IP is
allocated to the printer using the format
nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127
and any value in the range of 224 to 254 cannot be
specified for the first octet of a gateway address.