Filter
Top Products
Level 2 Options
If you select INDIVIDUAL, the next step is assigning memory to
each channel. Any channel using the LJ-3, LQ, or FX printer mode
requires at least 0.5MB of memory, and any channel using
PostScript or Epson GL (available on optional identity cards)
requires at least 1.5MB. (Add the requirements of all three
channels together to determine the minimum total memory
required.)
You assign the memory using a value from 0 to 9 for each channel.
The factory setting is S:o P:1 O:o. If you want to change the ratio,
assign an appropriate number to each channel. For example, if you
are using PostScript in the S channel and HP LJ-3 in the I’ channel
and nothing in the O channel, you could use S:3 P:l O:o because
PostScript requires approximately three times as much memory as
HP LJ-3.
After choosing INDIVIDUAL, press to move to the following
display:
The number on the left is the total number of megabytes available,
and the number to the right of each channel is the proportion of
memory allocated to that channel. Use the arrow buttons to choose
the new values for each channel. After you finish the memory
allocation, press The display shows the following:
Menu/submenu
Available options
< (cancel) or >
(execute)
Press to save the settings and restart the printer or press
to cancel the settings.
SelecType
3-33