Filter
Top Products
Power Supply
Power is not being supplied to the printer.
After you turn on the printer, the display panel remains blank.
l The power cable may be disconnected or may not be
completely plugged into the electrical outlet. Turn off the
printer and check the power cable connections between the
printer and the electrical outlet; then turn the printer back on.
l The problem may be with the electrical outlet itself. If the
outlet is controlled by an outside source such as a wall switch,
make sure it is on. If the printer still does not operate, plug
another electrical device into the outlet to check whether the
outlet is operating properly.
The printer turns on briefly, but then the display goes blank and
the printer motor and fan stop running.
l The voltage may not be correct for your printer. Turn off the
printer and make sure the voltage of your electrical outlet
matches the rating indicated on the label at the back of the
printer. If the voltages match, try turning on the printer again.
If the voltages do not match, disconnect the power cable and
contact your dealer immediately.
Troubleshooting
6-21