Filter
Top Products
SelecType Problems
After turning on the printer, the message START UP ERROR is
displayed and your previously selected settings have changed.
•
This message may appear if you turned off the printer while it
was in the process of saving settings made with the FACTORY
RESET option in SelecType Level 2. If this occurs, the settings
may not have been saved. Run the status sheet to check
SelecType settings and reset them if necessary as described in
Chapter 3.
After changing printer modes, you find that your previous
SelecType Level 2 settings for that mode have changed.
•
You may be trying to set up different SelecType Level 2
configurations for a number of printer modes. This is not
possible because SelecType Level 2 settings are not specific to a
particular printer mode. For example, if you change the I/F
CONFIG setting from PARALLEL to SERIAL in one mode and
save it with P-CONFIG SAVE, the change is reflected in all
printer modes. However, you can save up to four separate
configurations for SelecType Level 1 as macros.
6-30 Troubleshooting