Filter
Top Products
B-3
Fiber Matrix 6400 Switcher • Specications, Part Numbers, Accessories
Digital video — 3G HD-SDI I/O board (multi-rate SDI)
Routing ........................................... 8 x 8 matrix per I/O card, up to 64 x 64
Gain ................................................. Unity
Maximum data rate....................... 2.97 Gbps
Data types ....................................... 8 or 10 bit
Operation standards ..................... SMPTE 292M, SMPTE 259M, SMPTE 424M, ITU-RBT.601, ITU-RBT.1120
Digital video input — 3G HD-SDI I/O board (multi-rate SDI)
Number/signal type ..................... 8 single link SDI, HD-SDI, or 3 Gbps HD-SDI
Connectors ..................................... 8 female BNC
Nominal level ................................ 0.80 Vp-p ±10%
Impedance ...................................... 75 ohms
Return loss ...................................... <-15 dB @ 1 MHz to 1.5 GHz
Equalization ................................... Automatic
Input cable equalization distance
HD-SDI
Extron SHR, Belden 1694A cable
492’ (150 m)
Extron HR, Belden 1505A cable
328’ (100 m)
SDI
Extron SHR, Belden 1694A cable
984’ (300 m)
Extron HR, Belden 1505A cable
656’ (200 m)
N
The transmission distance varies depending on the signal resolution and on the type of cable,
graphic card, and display used in the system.
Digital video output — 3G HD-SDI I/O board (multi-rate SDI)
Number/signal type ..................... 8 single link SDI, HD-SDI, or 3Gbps HD-SDI
Connectors ..................................... 8 female BNC
Nominal level ................................ 0.80 Vp-p ±10%
Return loss ...................................... <-15 dB @ 1 HHz to 1.5 GHz
DC offset ......................................... ±0.5 V with input at 0 offset
Re-clocking ..................................... Automatic, or use available bypass mode for nonstandard rates
Jitter ................................................. <0.2 VI
Rise/fall time (20-80%)
SDI ....................................... 700 ps ±100 ps
HD-SDI ............................... 250 ps ±100 ps
Control/remote — switcher
Serial control port .......................... 1 bidirectional RS-232 or RS-422, 9-pin female D connector (rear panel)
1 bidirectional RS-232, 2.5 mm mini stereo jack (front panel )
Baud rate and protocol ................. 9600 to 115200 baud, 9600 baud (default), 8 data bits, 1 stop bit, no parity
Serial control pin configurations
9-pin female D connector . RS-232: 2 = TX, 3 = RX, 5 = GND
RS-422: 2 = TX-, 3 = RX-, 5 = GND, 7 = RX+, 8 = TX+
Mini stereo jack .................. RS-232: tip = TX, ring = RX, sleeve = GND
Ethernet control port..................... 1 RJ-45 female connector
Ethernet data rate .......................... 10/100Base-T, half/full duplex with autodetect
Ethernet protocol ........................... ARP, DHCP, ICMP (ping), TCP/IP, UDP, Telnet, HTTP, SMTP