Extron electronic 6400s Switch User Manual


  Open as PDF
of 148
 
3-9
Fiber Matrix 6400 Switcher • Operation
Creating a configuration
The current configuration can be changed using the front panel buttons. Change
the current configuration as follows:
1. Press the Esc button to clear any front panel button indications that may be lit.
2. Select the desired input and output(s) by pressing the input and output
buttons. Input buttons and output buttons light or blink green to indicate ties.
• Toindicatepotential ties, output buttons blink when an input is
selected.
• Toindicatecurrent ties, output buttons light steadily when an input is
selected.
• Toclearunwantedoutputs,pressandreleasetheassociatedlitoutput
buttons. To indicate potential unties, output buttons blink when an
output is deselected but not untied from the input.
3. Press and release the Enter button to accept the tie.
4. Repeat steps 1 through 3 to create or delete additional ties until the desired
configuration is complete.
N • Onlyoneinputcanbetiedtoanoutput.
• Ifatieismadebetweenaninputandanoutput,andtheselectedoutputwas
previously tied to another input, the older tie is broken in favor of the newer
tie.
• Ifaninputwithnotieisselected,onlythatinput’sbuttonlights.
• Aseachinputandoutputisselected,theassociatedoutputbuttonblinksto
indicate a tentative tie. Buttons for output(s) that were already tied to the
input light steadily. Outputs that are already tied can be left on, along with
new blinking selections, or toggled off by pressing the associated output button.
• IfyoupresstheinputbuttonforanI/Ogroupedinputandthentrytoselect
an output in a different group, you cannot select the associated output
button. The associated input button remains lit.
• Anopticalinputcanbetiedtoopticaland/orSDI/HD-SDIoutputs,andan
SDI/HD-SDI input can be tied to SDI/HD-SDI and/or optical outputs.
 previous next