Filter
Top Products
2-9
Fiber Matrix 6400 Switcher • Installation
Front Panel Configuration Port
FIBER MATRIX 6400
CONTROL
CONFIG
ENTERPRESET
VIEW
ESC
FIBER OPTIC DIGITAL MATRIX SWITCHER
POWER SUPPLY
PRIMARY
REDUNDANT
1
Figure 2-6 — Front panel configuration port
a
Configuration port — This 2.5 mm mini stereo jack serves the same serial
communications function as the rear panel Remote port, but it is easier
to access than the rear port after the matrix switcher has been installed
and cabled. The optional 9-pin D to 2.5 mm mini jack TRS RS-232 cable,
part #70-335-01 (figure 2-7), can be used for this connection.
6 feet
(1.8 m)
Part #70-335-01
5
1
9
6
Sleeve (Gnd)
Ring
Tip
9-pin D Connection TRS Plug
Pin 2 Computer's RX line Tip
Pin 3 Computer's TX line Ring
Pin 5 Computer's signal ground Sleeve
Figure 2-7 — Optional 9-pin TRS RS-232 cable
N
This port is independent of the rear panel Remote port and is not affected by
changes to the rear panel port’s protocol. This front panel port’s protocol can be
changed under SIS command control only. See the Command/Response table for
IP-specific SIS commands, in chapter 4, “Programmer’s Guide”, to configure all
ports under SIS control.
N
A front panel Configuration port connection and a rear panel Remote port
connection can both be active at the same time.