Filter
Top Products
Command ASCII (Telnet)
(host to processor)
URL Encoded (Web)
(host to processor)
Response
(processor to host)
Additional description
Set IP address
24
E X1$CI } WX1$CI
|
Ipi • X1$ ] X1$ = IP address (xxx.xxx.xxx.xxx).
Leading zeros in each of the four fields are
optional in setting values.
Read IP address
24
ECI }
WCI
|
X1$]
Leading zeros in each of the four fields are
suppressed in returned values.
Read hardware
address (MAC)
ECH }
WCH
|
X1*] X1* = hardware media access control (MAC)
address (xx-xx-xx-xx-xx-xx).
Set subnet mask
24
E X1(CS} WX1(CS
|
Ips•X1( ] X1( is the subnet mask (xxx.xxx.xxx.xxx).
Syntax is the same as for the IP addresses.
Leading zeros are optional in setting values.
Read subnet mask
ECS} E WCS
|
X1( ]
Leading zeros are suppressed.
Set gateway IP address
24
E X1$CG} W X1$CG
|
Ipg•X1$ ] X1$ is the IP address. Leading zeros are
optional.
Read gateway IP address
ECG} WCG
|
X1$ ]
Set broadcast mode
E X6$,X1$EB} W X6$%2C X1$EB
|
BmdX6$, X1$ ]
Set administrator password
24
E X3#CA} WX3#CA
|
Ipa•X3# ]
Set the administrator access password.
(X3# is 4-12 alphanumeric characters)
The password is case sensitive. Special
characters (spaces or symbols) are
not allowed.
Clear administrator
password
24
E•CA}
W%20CA
|
Ipa• ]
Clear/remove all passwords (administrator
and user)
NOTE: A user password cannot be assigned if an administrator password does not exist. Entering a password when the DVS 304 has not been congured yields an
E14 response from the processor. If the administrator password is cleared (removed), the user password is also removed.
Read administrator password
ECA} WCA
|
X3# ]
NOTE: X% = On/Off 0 = off/disable, 1 = on/enable
X1$ = IP address (xxx.xxx.xxx.xxx); leading zeros in each of 4 elds are optional in setting values, and are suppressed in returned values.
X1* = Hardware (MAC) address (xx-xx-xx-xx-xxxx)
X1( = Subnet mask (xxx.xxx.xxx.xxx). Leading zeros are optional in setting values in each of four fields, and are suppressed in returned values.
X3# = Password (12 characters = maximum length; no special characters are allowed).
X6$ = Broadcast repetition rate in seconds (0 – 255 max; default = 0 = clear). The response is returned with leading zeros. 1 – 11 = entry without password goes to the level
specified (if an admin password exists). The response as returned as 2-digits with a leading zero.
DVS 304 Series • SIS Communication and Control 49