Filter
Top Products
Introduction, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Introduction
1-8
Labeling — The included Extron Button Label Generator software lets you create
labels to place in the front panel I/O buttons, with names, alphanumeric
characters, or color bitmaps for easy and intuitive input and output selection.
Alternatively, labels can be made with any Brother
™
P-Touch
™
or comparable
labeler.
Global memory presets — 64 global memory presets are a time-saving feature that
lets you set up and store input/output configurations in advance. You can
then recall those configurations, when needed, with a few simple steps.
Rack mounting — Rack mountable in any conventional 19-inch wide rack
Front panel security lockout (Executive mode) — If a matrix switcher BME with
a QS-FPC is installed in an open area where operation by unauthorized
personnel may be a problem, a security lockout feature can be implemented.
When the front panel is locked, a special button combination or SIS command
is required to unlock the front panel controller before it can be operated.
I/O grouping — Allows the matrix to be virtually divided into smaller
sub-switchers, making installation and control easier. I/O grouping allows
specific inputs and outputs, such as those designated for a specific purpose,
to be grouped together. I/O grouping limits the selection of inputs and
outputs to members of the same group.
Primary and redundant power supplies — Includes two internal 100 VAC
to 240 VAC, 50-60 Hz power supplies that provide worldwide power
compatibility.
The power supply circuitry is configured to automatically switch over from
the primary supply to the hot redundant supply in the case of a failure.
The hot redundant power supply means high reliability for the system and
no loss of functionality should the primary supply fail; the redundant power
supply immediately assumes the load.
Power supply status LEDs — Front panel LEDs indicate the status of the primary
and redundant power supplies.