Filter
Top Products
Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation
3-14
Example 1: Creating a set of ties
In the following example, input 5 video and audio are tied to outputs 3, 4, and 8.
The steps show the front panel indications that result from your actions.
N
This example assumes that there are no ties in the current configuration.
1. Clear all selections: Press and release the Esc button.
C O N T R O L
PRESET
ENTER
ESCVIEW
Press the Esc button to clear all selections.
The button flashes once.
2. Select video and audio for the tie: If necessary, press and release the RGBHV
(CrossPoint 450 Plus switchers) or Video (MAV Plus video switchers) button
and the Audio button until the buttons light.
I / O
RGBHV AUDIO
Press the RGBHV or Video button to toggle on and off.
The button lights green when selected.
Press the Audio button to toggle on and off.
The button lights red when selected.
3. Select an input: Press and release the input 5 button.
17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8
25
9
I
N
P
U
T
S
I
N
Press and release the Input 5 button.
The button lights amber to indicate that RGBHV or video
and audio outputs can be tied to this input.
4. Select the outputs: Press and release the output 3, output 4, and output 8
buttons.
C O N T R O L
PRESET
ENTER
ESC VIEW
17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8
25
9
O
U
T
Press and release the Output 3, Output 4, and Output 8 buttons.
The buttons blink amber to indicate that the selected RGBHV or video and audio
input will be tied to these outputs.
The Enter button blinks
to indicate the need to
confirm the change.
N
You can cancel the entire set of ties at this point by pressing and releasing the
Esc button. The Esc button flashes once.