Filter
Top Products
3-9
CrossPoint 450 Plus and MAV Plus Switchers • Operation
I/O control buttons
Primary functions
Action
Select video. Select audio.
Indication
Green when selected Red when selected
RGBHV
or
VIDEO
AUDIO
Secondary functions
Front panel
locks
Action 1
With Enter, select Lock mode 2 or toggle between
mode 0 and mode 2.
Action 2
Select Lock mode 1 or toggle between mode 2 and
mode 1.
RGB delay Action
Select
RGB Delay mode.
Indication
Blinking: selected
Resets Action
Perform a system reset
Port
configuration
Action
Select RS-232. Select RS-422.
Indication
Blinking: selected Blinking: selected
Audio Action
Select Audio mode.
Indication
Blinking: selected
You must specify video, audio, or both when you are creating or viewing a
configuration. This is done with the RGBHV button (CrossPoint switchers) or
Video button (MAV Plus switchers) (
g
) and Audio (
h
) buttons.
g
RGBHV (CrossPoint 450 Plus) button or Video (MAV Plus) button — The
RGBHV (CrossPoint 450 Plus switchers) or Video (MAV Plus video switchers)
button has one primary function (•) and five secondary (❏) functions:
• Selects and deselects video for a configuration that is being created or
viewed and lights green to indicate that video is available for configuring
or for viewing.
❏
With the Enter button and Audio button, selects between front panel
locks (Lock mode 2 and Lock mode 0). See “Setting the front panel locks
(Executive modes)” on page 3-43.
❏
With the Audio button, toggles the front panel lock on or off. See "Setting
the front panel locks (Executive modes)" on page 3-43.
❏
With the Audio button, commands the front panel system reset. See
"Performing a system reset from the front panel" on page 3-44.
❏
(Systems with CrossPoint 450 Plus Wideband switcher BMEs) Selects
the
RGB delay mode, in which you can set the RGB delay. See "Setting
RGB delay (systems with wideband BMEs)" on page 3-27.
❏
Selects the RS-232 protocol for the RS-232/RS-422 port in Serial Port
Configuration mode and indicates the selection. See "Selecting the rear
panel Remote port protocol and baud rate" on page 3-46.