Filter
Top Products
Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation
3-6
Control buttons
Primary functions
Action
Save changes Select Preset mode Select View mode Cancel/escape
Indication
Blinking: save needed Blinking: Save preset
Lit: Recall preset
View mode selected Flashes once
ENTER PRESET
VIEW
ESC
Secondary functions
I/O Grouping Action
Select group 1. Select group 2. Select group 3. Select group 4.
Indication
Lit: group selected. Lit: group selected. Lit: group selected. Lit: group selected.
Port
configuration
Action 1
Select Configuration mode
Action 2
Select 9600 baud. Select 19200 baud. Select 38400 baud. Select 115200 baud.
Indication
Blinking: rate selected Blinking: rate selected Blinking: rate selected Blinking: rate selected
Front panel
locks
Action
With Video and
Audio, select Lock
mode 2 or toggle
between mode 0 and
mode 2.
RGB delay Action
CrossPoint:
In
RGB Delay
mode, decrease the
switching interval.
In RGB Delay
mode, increase the
switching interval.
Audio Action
In Audio mode,
decrease input level
or output volume.
In Audio mode,
increase input level
or output volume.
c
Enter button — The Enter button has two primary functions (•) and four
secondary (❏) functions:
• Saves configuration or preset changes that you make on the front panel.
To create a simple configuration:
a
. Specify RGBHV (CrossPoint 450 Plus switchers) or Video (MAV Plus
switchers), Audio, or both (see I/O selection buttons [
g
] and [
h
]).
b
. Press the desired input button (
a
).
c
. Press the desired output button(s) (
b
).
d
. Press the Enter button.
• Indicates that a potential tie has been created but not saved.
❏ In the I/O Group mode, selects group 1 and indicates the selection. See
"I/O grouping" on page 3-23.
❏
With the Preset, View, and Esc buttons, selects Serial Port Configuration
mode. See "Selecting the rear panel Remote port protocol and baud rate"
on page 3-46.
❏
Selects 9600 baud for the RS-232/RS-422 port in Serial Port Configuration
mode and indicate the selection. See "Selecting the rear panel Remote
port protocol and baud rate" on page 3-46.
❏
With the RGBHV/Video and Audio buttons, selects front panel security
Lock mode 2 or toggle between mode 0 (unlocked) and mode 2. See
“Setting the front panel locks (Executive modes)” on page 3-43.