Filter
Top Products
Chapter 10 Component Management
10.2 Functions in the Action Area for Component
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
695
10.2.1 Add Drive Enclosure
This function enables DEs to be added without stopping the ETERNUS DX Disk storage system.
Use GUI to install any DEs that are added.
Specify between DE#01 - DE#09 for the drive enclosures that are to be added.
The procedure to expand a DE is as follows:
Procedure
1 Click [Add Drive Enclosure] in [Action].
→ The start screen appears.
• When logged in using a user account with the "Admin" default role, this function is available only with
the ETERNUS DX80 S2/DX90 S2. To use this function with the ETERNUS DX410 S2/DX440 S2 or the
ETERNUS DX8100 S2/DX8700 S2, a user account with the "Maintainer" default role (or "Maintenance
Operation" policy) is required.
• Only one DE can be added at a time.
• 2.5-inch type DEs and 3.5-inch type DEs can be installed in the same ETERNUS DX Disk storage system.
• Be sure to use authorized expansion parts. If parts other than the expansion parts are used, operation is
not guaranteed.
• This function cannot be used under the following conditions:
- When the general status of the ETERNUS DX Disk storage system is other than "Normal"
- When DE#09 is already installed (when the status of DE#09 is " Normal")
• If expansion fails due to an error or problem, the expansion can be restarted from the interrupted point
by starting this function again and recovering the failed expansion parts.
• DEs can be added regardless of whether drives are installed or not.