Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
883
• Temperature Error
Select whether to notify when a temperature error status is detected by the sensor. When notifying,
select the notification method.
• End of battery life
Select whether to notify when a battery expires. When notifying, select the notification method.
"End of battery life" notification is available only for the ETERNUS DX410 S2/DX440 S2 or the
ETERNUS DX8100 S2/DX8700 S2.
• Rebuild/Copyback w/ redundant
Select whether to notify when rebuilding or copy backing (with redundancy) (*1) is performed.
When notifying, select the notification method.
*1: "Rebuilding to hot spare disk is complete", "Copyback starts" and "Copyback complete" are equivalent
to "Redundancy".
• Rebuild/Copyback w/o redundant
Select whether to notify when rebuilding or copy backing (without redundancy) (*1) occurs for each
condition shown below. When notifying, select the notification method.
- Any Time
Always notifies when rebuilding or copy backing (without redundancy) occurs.
- when HS<0
Notifies only if rebuilding or copy backing (without redundancy) occurs when the available hot
spare disk is "0".
*1: "Rebuild to hot spare disk is started", "Rebuild to hot spare disk failed" and "Copyback failed" are
equivalent to "Without redundancy".
• Redundant
Select whether to notify when a redundant copy starts or ends abnormally for each condition shown
below. When notifying, select the notification method.
- Any Time
Always notifies when a redundant copy starts or ends abnormally.
- when HS<0
Notifies only if a redundant copy starts or ends abnormally when the available hot spare disk is
"0".
• Complete Redundant Copy
Select whether to notify when a redundant copy is complete. When notifying, select the notification
method.
• Complete rebuild
Select whether to notify when a bad sector (*1) is detected in the hot spare where rebuilding is
completed. When notifying, select the notification method.
*1: A bad sector is the location information (address and length) where an error such as data reading error
occurs during rebuild, copyback, or redundant copy.
• Bad data
Select whether to notify when a bad sector is detected in the drive. When notifying, select the
notification method.