Filter
Top Products
Chapter 3 - Quick-Start Procedures
3-2
3.1 Operation using Keypad
1. Apply AC power.
2. LCD: Press [▲
] key three times.
7-Seg: Rotate the encoder knob until ‘03’ is
displayed.
3. LCD: Press [PROG] key.
7-Seg: Press[PROG/ENT] key.
4. LCD: Press [▼] key one time.
7-Seg: Rotate the encoder knob left.
5. LCD: Press [PROG] key.
7-Seg: Press [PROG/ENT] key.
6. Press [PROG/ENT] key.
7. LCD: Press [PROG] key.
7-Seg: Press [PROG/ENT] key.
8. LCD: Press [SHIFT/ESC] key and press [▲
]
key to increase the command frequency.
7-Seg: Rotate the encoder knob right to change
the command frequency.
The changing digit moves
by pressing the
[SHIFT/ESC] key.
9. LCD: Press [ENT] key to save the data.
7-Seg: Press [PROG/ENT] key to save the data.
10. LCD: Press [FWD] or [REV] key to start motor.
7-Seg: Press [RUN] key to start motor.
11. Press [STOP/RESET] key to stop motor.
LCD Display
7-Segment Display
DRV
►
T/K 0.0 A
00 STP 0.00Hz
DRV
► Cmd. freq
00 0.00Hz
DRV
► Cmd. freq
00 60.00Hz
DRV
►
K/K 0.0 A
00 STP 60.00Hz
DRV
►
Drive mode
03 Fx/Rx-1
DRV
►
Drive mode
03 Fx/Rx-1
DRV
►
Drive mode
03 Keypad
DRV
►
Drive mode
03 Keypad
The PROG/ENT LED turned ON.
The PROG/ENT LED is turned ON.
The DRV LED is ON.
The DRV LED is turned ON.
DRV
►
K/K 0.0 A
00 STP 0.00Hz
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned ON.
The FWD or REV LED starts blinking.
The RUN LED starts blinking.
To change the motor running
direction
,
chan
g
e DRV 13 to ‘1’.
The STOP/RESET LED starts blinking.
The STOP/RESET LED starts blinking.