Filter
Top Products
126 Chapter 6 - Copying EN
Changing the default copy quality
The choices for this setting are Text (the factory default), Photo, and
Draft.
Note If you only want to adjust the quality for the job you are currently
copying, see “Adjusting copy quality for the current job” on page 123.
To change the default copy quality
1 Press ENTER/MENU.
2 Use the < or > key to select
COPY SETUP and then press ENTER/
M
ENU.
3 Use the < or > key to select
DEFAULT QUALITY and then press
E
NTER/MENU.
4 Use the < or > key to select
TEXT (the factory default), PHOTO, or
DRAFT.
5 Press E
NTER/MENU to save your selection.
Changing the default copy contrast
Contrast is the difference between the dark and light areas of an
image. The slider is set to the middle as the default copy contrast
setting.
Note If you only want to adjust the contrast for the job you are currently
copying, see “Using the Contrast button to adjust the contrast for the
current fax or copy job” on page 122.