Filter
Top Products
EN Resolving control panel error messages 195
Resolving control panel error messages
These control panel error messages are listed alphabetically.
Messages are accompanied by cause for the message and steps to
take to resolve the problem.
Message Cause Solution
###: [GROUP
NAME] ONE-
TOUCH/SPEED
DIAL
The product is waiting for you to press a
programmed one-touch key or to enter a
speed-dial code to a group-dial code.
Begin adding fax numbers to the group-
dial code. See “Programming group-dial
codes” on page 74.
50.X FUSER
ERROR
The product has experienced an internal
hardware error.
Disconnect the power cable from the
product, wait at least 30 seconds, then
reconnect the power cable and wait for
the product to initialize. If the message
does not clear, the product will need
service.
51 LASER
ERROR
The product has experienced an internal
hardware error.
Disconnect the power cable from the
product, wait at least 30 seconds, then
reconnect the power cable and wait for
the product to initialize. If the message
does not clear, the product will need
service.
52 SCANNER
ERROR
The product has experienced an internal
hardware error.
Disconnect the power cable from the
product, wait at least 30 seconds, then
reconnect the power cable and wait for
the product to initialize. If the message
does not clear, the product will need
service.
53.X PRINTER
ERROR
The product has experienced an internal
hardware error.
Disconnect the power cable from the
product, wait at least 30 seconds, then
reconnect the power cable and wait for
the product to initialize. If the message
does not clear, the product will need
service.
54.X PRINTER
ERROR
The product has experienced an internal
hardware error.
Disconnect the power cable from the
product, wait at least 30 seconds, then
reconnect the power cable and wait for
the product to initialize. If the message
does not clear, the product will need
service.
55 DC
CONTROLLER
ERROR
The product has experienced an internal
hardware error.
Disconnect the power cable from the
product, wait at least 30 seconds, then
reconnect the power cable and wait for
the product to initialize. If the message
does not clear, the product will need
service.