Filter
Top Products
1. Gracefully shut down the operating system. See Appendix B (page 125), or your operating
system documentation.
2. Press the Power button to power off the server.
IMPORTANT: The main DC voltage is now removed from the server; however, AC voltage
for standby power is still present in the server.
3. Unplug all power cables from the receptacles on the rear panel of the server.
Powering On the Server
Power on the server to full power using the following methods if the server is in the standby
power state:
• iLO MP PC command
• Power button
Powering On the Server Using iLO
NOTE: If the power restore feature is set to Always On through the iLO MP PR command, the
server might automatically power on to the full power state.
To power on the server through iLO:
1. Plug all power cables into the receptacles on the rear panel of the server.
2. Initiate a console session, and access the iLO MP Main Menu.
3. Enter CM to enable command mode.
4. Enter PC to use the remote power control command.
5. Enter ON to power on the server, and enter YES when prompted to confirm the action.
6. Start the operating system. See Appendix B (page 125), or your operating system
documentation.
Powering On the Server Manually
NOTE: If the power restore feature is set to Always On through the iLO MP PR command, the
server might automatically power on to the full power state.
To manually power on the server:
1. Plug all power cables into the receptacles on the rear panel of the server.
2. Press the Power button to start the server.
3. Start the operating system. See Appendix B (page 125), or your operating system
documentation.
38 Powering Off and Powering On the Server