Filter
Top Products
3. Lift up on the battery and push on the back of it with a flat-head screwdriver to remove the
battery from its holder. See Figure 4-38 for the battery location on the system board.
CAUTION: Only lift the battery high enough to clear the holder. Excessive stress on the
battery holder retaining clip can damage the clip.
Figure 4-38 Removing the System Battery
Replacing the System Battery
1. Lift up on the battery holder retaining clip with a flat-head screwdriver and slide the battery
into the holder. The positive (+) terminal of the battery faces up.
CAUTION: Only lift the battery high enough to clear the holder. Excessive stress on the
battery holder retaining clip can damage the clip.
2. Install the top metal cover. See “Replacing the Top Metal Cover” (page 44).
3. Reconnect all of the power and external cables and power on the server.
4. Verify the battery replacement by using the utilities identified in Appendix C (page 141). To
verify operation, use the iLO MP commands.
5. You might need to reset the server time and date using the EFI time and date commands.
After you set the time, power off the server, unplug the power cord, and wait for one minute
before powering on. Execute the time and date commands again. If the time and date are
correct, you have installed the battery correctly.
70 Removing and Replacing Components