Filter
Top Products
4 Removing and Replacing Components
This chapter describes the procedure for removing and replacing the different components in
the server.
ESD Information
Follow the procedures listed below to ensure safe handling of components and to prevent harm
to both you and the server:
• Use an anti-static wrist strap and a grounding mat, such as those included in the Electrically
Conductive Field Service Grounding Kit (HP 9300-1155).
• Handle accessory boards and components by the edges only. Do not touch any metal-edge
connectors or any electrical components on accessory boards.
• Do not wear clothing subject to static charge build-up, such as wool or synthetic materials.
Required Tools
Service of this product might require one or more of the following tools:
• IPF CPU Installation Tool Kit (P/N 5069-5441), consisting of:
• Disposable ESD Kit
• Label-less CPU install tool (2.5mm hex and T-15 Torx screwdrivers)
• 1/4 inch standard screwdriver
• Phillips No. 1 Screwdriver
• ACX-10 Torx screwdriver
• ACX-15 Torx screwdriver
• ACX-25 Torx screwdriver
Internal Component and Connector Locations
Figure 4-1 and Table 4-1 show the locations of the internal server components.
ESD Information 39