Filter
Top Products
Solution
• Make sure the HP All-in-One is connected to the port that is designated for fax and phone
use. Also, make sure that the terminal adapter is set to the correct switch type for your
country/region, if possible.
NOTE: Some ISDN systems allow you to configure the ports for specific phone
equipment. For example, you might have assigned one port for telephone and Group
3 fax and another port for multiple purposes. If you have problems when connected to
the fax/phone port of your ISDN converter, try using the port designated for multiple
purposes; it might be labeled "multi-combi" or something similar.
For more information on how to set up the HP All-in-One with a PBX phone system or ISDN
line, see “
Case C: Set up the HP All-in-One with a PBX phone system or an ISDN line”
on page 24.
• Try setting the Fax Speed to Medium (14400) or Slow (9600).
Cause: The Fax Speed setting is set too fast.
Solution: You might need to send and receive faxes at a slower rate. Try setting the Fax
Speed to Medium (14400) or Slow (9600) if you use one of the following:
• An Internet phone service
• A PBX system
• Fax over Internet Protocol (FoIP)
• An ISDN service
Cause: The HP All-in-One might be connected to a telephone wall jack that is set up for digital
phones.
Solution: Make sure you connect the HP All-in-One to an analog phone line or you will not be
able to send or receive faxes. To check if your phone line is digital, connect a regular analog
phone to the line and listen for a dial tone. If you do not hear a normal sounding dial tone, it
might be a phone line set up for digital phones. Connect the HP All-in-One to an analog phone
line and try sending or receiving a fax.
Cause: The HP All-in-One shares the same phone line with a DSL service and the DSL modem
might not be properly grounded.
Solution: If the DSL modem is not properly grounded, it can create noise on the phone line.
Phone lines with poor sound quality (noise) can cause faxing problems. You can check the sound
quality of the phone line by plugging a phone into the telephone wall jack and listening for static
or other noise.
If you hear noise
1. Turn off your DSL modem and completely remove power for at least 15 minutes.
2. Turn the DSL modem back on.
3. Listen to the dial tone again. If the dial tone sounds clear (no noise or static), try sending or
receiving a fax.
NOTE: You might notice static on the phone line again in the future. If the HP All-in-One
stops sending and receiving faxes, repeat this process.
If the phone line is still noisy, contact your phone company. For information on turning your DSL
modem off, contact your DSL provider for support.
Cause: You are faxing over the Internet using an IP phone, and there was a problem with the
transmission.
Solution: Try resending your fax at a later time. Also, make sure your Internet service provider
supports faxing over the Internet.
Fax setup troubleshooting 61
Troubleshooting and support