Filter
Top Products
4. Scroll down the list of services, right click HP Network Devices Support, and then
click Restart.
5. After the service restarts, try using the HP device over the network again.
If you are able to use the HP device over the network, your network setup was successful.
If you still cannot use the HP device over the network or if you have to periodically perform
this step in order to use your device over the network, your firewall might be interfering.
If this still does not work, there might be a problem with your network configuration or
router. Contact the person who set up your network or the router manufacturer for help.
Add hardware addresses to a wireless access point (WAP)
MAC filtering is a security feature in which a wireless access point (WAP) is configured
with a list of MAC addresses (also called “hardware addresses”) of devices that are
allowed to gain access to the network through the WAP. If the WAP does not have the
hardware address of a device attempting to access the network, the WAP denies the
device access to the network. If the WAP filters MAC addresses, then the device’s MAC
address must be added to the WAP’s list of accepted MAC addresses.
• Print the network configuration page. For more information, see
Understand the
network configuration page (some models only).
• Open the WAP’s configuration utility, and add the device’s hardware address to the
list of accepted MAC addresses.
Configure your firewall to work with HP devices
A personal firewall, which is security software running on your computer, can block
network communication between your HP device and your computer.
If you are having problems such as:
• Printer not found when installing HP software
• Unable to print, print job stuck in queue or printer goes offline
• Scan communication errors or scanner busy messages
• Unable to see printer status on your computer
The firewall might be preventing your HP device from notifying computers on your network
where it can be found. If the HP software cannot find the HP device during installation
(and you know the HP device is on the network), or you have already successfully
installed HP software and experience problems, try the following:
1. If you are using a computer running Windows, in the firewall configuration utility, look
for an option to trust computers on the local subnet (sometimes called the “scope“ or
“zone“). By trusting all computers on the local subnet, computers and devices in your
home or office can communicate with each other while still being protected from the
internet. This is the easiest approach to use.
2. If you do not have the option to trust computers on the local subnet, add incoming
UDP port 427 to your firewall’s list of allowed ports.
NOTE: Not all firewalls require you to differentiate between incoming and
outgoing ports, but some do.
Configure your firewall to work with HP devices 119