Filter
Top Products
92 Chapter 7 Output devices ENWW
3,000-sheet stacker
Paper handling features
● Stacks up to 3,000 sheets of A4- or Letter-size paper
● Stacks up to 1,500 sheets of A3- or Ledger-size paper
● Can offset jobs, or offset the first page of jobs, if desired
The lower bin (face-down bin) is the default bin for all output jobs.
3,000-sheet stacker/stapler
Paper handling features
● Stacks up to 3,000 sheets A4- or Letter-size paper
● Stacks up to 1,500 sheets of A3- or Ledger-size paper
● Can offset jobs, or offset the first page of jobs, if desired
The upper bin (face-up bin) is the default bin for all output jobs.
Using the stapler
The 3,000-sheet stacker/stapler can staple documents that contain between two pages and
50 pages of 75 g/m
2
(20 lb) paper, or equivalent 5 mm (.2 inches). The pages must be
64 to 199 g/m
2
(17 to 53 lb) of all sizes supported by the MFP.
Keep in mind these additional points:
● The stacking bin can hold up to 3,000 sheets.
● Heavier media might have a stapling limit of fewer than 50 pages.
● If the job that you want stapled contains only one sheet, or if it contains more than 50 sheets,
the MFP copies or prints the job. However it will not staple.
You can usually select the stapler in your software program or printer driver, although some
options might be available only in the printer driver. Where and how you make selections
depends on your program or driver.
To select stapling when copying
1 Touch Copy.
2 Touch Side or Top, depending on where you want the documents to be stapled, and then
touch OK.
Note The page icon on the right side of the control panel shows the position of the staple.
To select stapling as the default setting at the control panel
1 Touch Menu.
2 Scroll to and touch Configure Device.
3 Scroll to and touch Copying.
4 Scroll to and touch Staple.
5 Scroll to and touch the staple quantity.