Filter
Top Products
Installing External System Devices
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-001
7-7
Installing a 5175 Open-Reel Tape Subsystem
c. Using the SCSI cable connector with the latch-clip flanges, attach the SCSI
cable to the uncapped SCSI port, and latch the clips as shown in Figure 7-5.
2. Attach the SCSI cable to the NonStop S-series server. See Attaching a SCSI Tape
Drive to the NonStop S-Series Server on page 7-15.
3. Connect the AC power cord:
a. Remove the shipping restraint for the AC power cord.
b. On the lower left side of the front panel of the tape subsystem, make sure the
standby push-button switch is in the OFF position.
c. Plug one end of the AC power cord into the AC power receptacle at the rear of
the tape drive CRU as shown in Figure 7-6 on page 7-8.
d. Plug the other end of the AC power cord into the designated power receptacle.
e. Close the back panel of the 5175 module. The panel is hinged at the bottom
and held in place at the top with push/pull fasteners.
4. Push the AC power switch as shown in Figure 7-6 on page 7-8.
Figure 7-5. Connecting a SCSI Cable to a 5175 Tape Subsystem
SCSI
Cable
Terminated
(Capped)
SCSI Port
Rear of 5175 Tape Drive CRU
Latch
Clip
Latch-Clip
Flange
Uncapped
SCSI Port
VST961.vsd