Filter
Top Products
FastPath Tasks: Required
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-001
E-28
6. Verify System Components
6. Verify System Components
Follow the instructions given in Verifying Topology and System Components on
page 8-14.
Ensure that the value for each attribute is as listed in Table 8-3, Checking the Attributes
of Selected System Components, on page 8-16.
7. Start System
1. After POSTs finish, green power-on LEDs should remain lit. No amber LEDs
should be lit. If any LEDs exhibit abnormal behavior, see Appendix D,
Troubleshooting.
2. Verify processor status:
a. On the menu bar, select Summary > Processor Status.
b. Verify that all processors have passed POST.
c. Close the Processor Status window.
3. From the toolbar, click Start System. The System Startup dialog box appears.
4. In the System Startup dialog box:
a. In the SYSnn field, enter 00 as the number of the SYSnn subvolume
containing the version of the operating system to be loaded.
b. In the Configuration File box, select Current (CONFIG).
c. Ensure the CIIN disabled option has no check mark in the selection box.
5. Click Start system. The system load begins.
The event stream and TACL windows open on the console where the START
SYSTEM was performed. If the workstation is not configured in the access list of
authorized workstations, the windows are blank.
The startup TACL window for the primary fabric contains a TACL prompt. The
startup event stream window for the primary fabric contains event messages. The
other two windows are blank.
Note. If the Power State attribute for a PMF CRU does not have a value of On, contact your
service provider.
Note. To stop startup, click Abort. Up to 30 seconds might pass before the abort takes effect.
Caution. Do not close the System Startup dialog box while startup is in progress. If you
attempt to do so, a message box indicates that the system startup process will stop if you
continue. If you stop a system startup before it has finished, results are unpredictable. You
might need to start the system again to enable it to resume normal operation.
Note. The startup TACL windows and startup event stream windows launch directly on top
of each other. You must move or minimize some of the window to see the active windows.