Filter
Top Products
Powering On and Starting the System
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-001
8-7
Power-On Procedure Using AC Power Cords
•
For enclosures that have power shelves, the AC power cords are shipped
preconnected to the power shelves. Use this procedure only if these cords are
not connected:
a. Start with the group 01 processor enclosure.
b. Insert the power cord into the retainer in the power shelf. See Figure 8-5.
Orient the molded end of the AC power cord with the single contact on
bottom, and insert the plug into the retainer until it is fully seated.
c. If you have difficulty inserting the plug into the retainer, you might need to
remove the power supply from the power shelf, insert the power cord into
the retainer, and reinstall the power supply.
d. Swing the locking bar down until it engages one of the slots on the plug
housing and snaps into place.
e. Repeat Step b through Step d for the other AC power cord for this
enclosure and for all remaining enclosures that have power shelves.
Figure 8-4. Connecting an AC Power Cord to an Enclosure With No Power Shelf
WARNING. The underside of the locking bar is sharp. Placing your fingers under the locking
bar can result in injury. Failure to fully seat the plug into the retainer can result in cord damage
from the locking bar.
VST708.vsd
Power Cord Retainer
Retainer Screw
Power Receptacle
AC Power Cord
Power Interlock
Ejector