Filter
Top Products
Configuring the System
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-001
10-14
Add a Server to an Unattended Site Configuration
Procedure
1. At the central site, install the system console to be used for monitoring the
unattended site.
a. Unpack and assemble the system console. See Unpacking and Assembling a
System Console on page 5-2.
b. Start and test the system console. See Starting and Testing a System Console
on page 5-8.
2. At the unattended site, construct a secure stand-alone network by using one of
these procedures:
3. See the TSM Configuration Guide for information about configuring the system
consoles at the central site and at the unattended site.
4. If your system uses OSM: Although OSM supports unattended site configurations,
automatic logon is not necessary. The OSM Notification Director runs as a
Windows service, so it does not need a user to be logged on in order to receive
and dial out incident reports. If you did not choose the option for the Notification
Director to run automatically as a service during OSM installation, you can change
the configuration without reinstalling OSM. See the OSM Notification Director
online help.
If your system uses TSM: reinstall TSM. Configure the workstation for automatic
logon at the unattended site.
Add a Server to an Unattended Site Configuration
See Add a Server to the Operating Configuration on page 10-8.
To construct this
network configuration See this topic
Setup configuration Setup Configuration
on page 10-2
Operating configuration Operating Configuration
on page 10-3